Detect people under suspended loads, at height without a harness or below elevated belts, with severity-rated alerts.
- Resources
Suspended loads, work at height and falling material share one consequence: a single failure can be fatal. Falls from height and falling objects caused more than one in five Australian workplace deaths in 2025 (Safe Work Australia). Exclusion zones, barricades, harness rules and spotters control these hazards, but supervisors and audits verify them only periodically.
This brief shows how Prism uses fixed cameras on site to measure compliance with your gravity risk controls. You define hazard zones for each camera, Prism analyzes existing CCTV at the edge, and every event is classified and rated critical, high or moderate by exposure, so repeat failures surface as patterns.
Inside the brief:
- Crane zones that activate only while a load is on the hook, so an alert means there is something to act on
- Harness detection on platforms, gantries and elevated walkways, with severity set by height and exposure
- Exclusion zones below elevated conveyors, with belt misalignment flagged before spillage at transitions
- Field evidence from an oil and gas drilling rig, where Prism ran crane zone detection in production
- How output reaches your PLC or SCADA, where your own logic decides the response
Written for site safety, critical control and process plant leads. Download the full solution brief to see how to know the risk before the drop or fall.
